Page 1 of 1
CP3 language setting is currently tied to the OS language
Posted: Mon Aug 17, 2026 4:29 pm
by ramirox3
Hello, I have already installed the filter ver 3. No matter how much I search, I cannot find how to change the language, the current language is Spanish, I would like to change it to English, which was the language that I always worked in version 2, so I am more familiar with the terms in that language. By the way, I had to write in this thread,
Well, it was impossible for me to find how to start a new thread or new post.
Re: Upgrade to CP3
Posted: Mon Aug 17, 2026 8:30 pm
by C.Oldendorf
At present, CP3 automatically follows the language of your operating system.
So, if your OS is set to Spanish, CP3 will also run in Spanish. If you switch the OS language to English, CP3 will switch to English as well.
There is currently no separate language setting within CP3.
Re: CP3 language setting is currently tied to the OS language
Posted: Mon Aug 17, 2026 8:58 pm
by C.Oldendorf
ramirox3 wrote: Mon Aug 17, 2026 4:29 pm
By the way, I had to write in this thread, Well, it was impossible for me to find how to start a new thread or new post.
No problem, I split it for you and here is how that works.
If you want to start a new thread, please follow the steps shown in the screenshots:
Do not click the headline marked 1. That is just the category heading.
Click one of the forums or subforums marked 2 that fits your topic.
Once you are inside that forum, click the “New Topic” button marked 3 to start a new thread.
So in short: don’t click 1 — click 2 first, then use 3 to create your thread.